AUSA D 1000 AP, Operator'S Manual

Page: 50 / 72

D 900 AP / D 1000 AP / D 1000 APG
48
(fi
g.
1)
(fi
g.
1)
(fi
g.
1)
Periodic
maintenance
operations
7.- Transfer box

Transfer box oil level (fig. 1)
a. Level cap
With the dumper on a level surface, check the oil level in the following way:
- Unscrew the level cap. The oil should spill out of the hole.
- If necessary, add oil through the same level hole.

Changing the transfer box oil
Oil changes should be carried out when the oil is warm.
- Clean the area around the drainage cap.
- Place a container underneath the oil drainage cap.
- Unscrew the oil drainage cap.
b. Oil drainage cap
- Change the joint in the oil drainage cap.
- Clean the reducer box joint area, the oil drainage cap and replace the cap.
- Refill the reducer box as per the recommended oil level. See the
LIQUIDS AND
LUBRICANTS section of the Manual for capacities.
- Ensure that there are no leaks from the oil drainage cap.
WARNING!!
Clean any oil spillage.

Oil level in planetary reductions (fig. 2, 3)
WARNING
Never remove the drain plug of the final reductions when the oil is hot. The
gases formed in the interior may cause injury.
Planetary reduction: Checking the level
- Turn the wheel until the mark “Oil Level” on the reducer is horizontal.
- To check the oil level in the final reductions use the cap (c) .
Planetary reductions: Draining
- Remove the wheel.
WARNING
If is necessary to remove the drain plug while the oil is still hot, place it on the
upper part of the wheel hub, and remove the plug carefully covering it with a
cloth or similar.
- To drain the oil, turn the wheel hub until plug (c) is located on the lower part of
the wheel hub.
Planetary reduction: Topping up
- Turn the wheel until the mark “Oil Level” on the reducer is horizontal.
- Fill with the specified oil through the opening of the plug (c) .
See the FLUIDS AND LUBRICANTS CHART (references and capacities) in
this Operator’s and Safety Manual for oil specs. and capacity.
a
b
c
c