D 900 AP / D 1000 AP / D 1000 APG
20
(fi
g.
3)
(fi
g.
2)
(fi
g.
4)
(fi
g.
1)
Controls
instruments
equipment
Control panel and controls
These are situated on the front operator protector and on the joystick.
1- Engine contact, preheating and stop switch (fig. 1)
This is located on the right side of the front protector.
a- Stopping
b- Preheating
c- Start-up
Switches (fig. 2).
D- Rotating
beacons
E- Horn.
F- Warning (only on light version dumpers)
These are located on the right side of the front protector. To turn on, press the button
and it will light up. To turn off, press the button again.
Indicators.
These are also situated on the right side of the front protector
(fig. 3)
.
G- Position lights lamp (only with lights option).
This lamp is lit when this type
of lights are selected.
H- High beam lights lamp (only with lights option).
This lamp is lit when this
type of lights are selected.
I- Indicator lamp (only with lights option).
This lamp blinks to signal a change
in direction with the indicators.
J- Engine temperature lamp.
If lit, this means that the engine temperature is too
high. Stop immediately in order to determine the cause of the problem. This could
be due to low level of coolant, dirt in the radiator, thermostat malfunction or a broken
alternator belt or water pump.
K- Air filter lamp.
Indicates when the air filter is dirty or obstructed
The filter element must be cleaned or changed immediately.
L- Engine oil pressure lamp.
When the contact is activated it will light and will turn
off when the engine is in operation. If the engine is functioning and the warning light
is lit, the engine must be stopped immediately to prevent any damage. Check the
oil level and add if necessary.
M- Preheating lamp.
When this lamp is lit it indicates that the engine glow plugs are
in operations and are heating the combustion chamber to a temperature which will
enable the firing of the vaporised diesel fuel.
N- Battery charge lamp.
With the contact activated, it will light when the alternator is
not charging the battery and it will go out when the engine starts to run. If it remains
lit, stop the engine and determine the cause.
O- Fuse box (fig. 4).
Located on the left side of the front protector
(O)
. The fuse box contains 11 fuses.
See the Electrical Circuit in this Manual to identify the number and function of each
fuse.
P- Hourmeter (fig. 4)
This is located underneath the fuse box
(P)
. The hourmeter records the time that
the engine is in operation, in hours. This allows the dumper maintenance to take
place at the appropriate periods.
See the
LUBRICATION AND MAINTENANCE CHART
section in this Manual.
1
a
b
c
D
F
E
J
N
I
M
H
L
P
G
K
O
Summary of Contents for D 1000 AP
