INSTALLATION INSTRUCTIONS
GENERAL SAFETY INFORMATION
1.
This installation must conform with local codes or, in the absence of local codes, with AS 5601.
2.
Provide adequate clearances around the product for servicing and ensure there are no obstructions to the combustion
air intake situated at the back of the heater. (Refer Page 5)
3.
The appliance must be installed on a flat, solid continuous surface (ie. wood, metal, concrete). Please Note: Rough
or uneven surfaces can cause vibration or humming in the heater.
4.
The Archer Gas Log Space Heater can be installed in a wide variety of ways and will fit nearly any room layout. It
may be installed in a recessed position, framed out into the room, or across a corner. For installation options refer
pages 13 through to 20.
5.
This appliance (Insert and Freestanding Console Models) needs to be installed in such a way that the heater can be
removed at all times to service the heat exchanger and flue fan located in the rear section of the heater.
Note: Under no circumstances should the appliance be installed under conditions, which would not allow
for easy removal of the appliance to carry out routine inspection and service to the appliance, to do
so will void the warranty.
Note: On Single Wall flue pipe installations (imitation zero clearance fireplace) a minimum of 25mm clearance must be
provided at the rear of the heater to enable the heater to get sufficient combustion air to the air inlet located at the
rear of heater.
Note: Where a mantel surround is being used on insert installations and imitation zero clearance fireplace
installations, the combustion air intake slot located in the top mantel surround must have no obstructions to allow
combustion air to enter through the slot to the combustion air inlet located at the back of the heater.
6
FAILURE TO INSTALL THIS APPLIANCE CORRECTLY MAY
CAUSE A SERIOUS HOUSE FIRE.
!
THIS APPLIANCE SHOULD BE INSTALLED BY A QUALIFIED
LICENSED GAS FITTER.
!
DUE TO HIGH TEMPERATURES, THE APPLIANCE SHOULD
BE LOCATED OUT OF TRAFFIC AND AWAY FROM
FURNITURE AND DRAPERIES.
!
THIS APPLIANCE CAN ONLY BE FLUED IN
A C C O R D A N C E W IT H T H E M A N U F A C T U R E R ’ S
INSTRUCTIONS AS TESTED TO AGA CODE 601.
!
IN CASES WHERE THE INSTALLATION OF THE HEATER IS
NOT IN ACCORDANCE WITH THE MANUFACTURERS
INSTRUCTIONS AND THE APPLIANCE CAN NOT BE
REMOVED FOR SERVICING IN SUCH CASES WHERE
SERVICE PERSONAL HAVE TO SPEND TIME TO REMOVE
THE HEATER OR CORRECT THE INSTALLATION A
SERVICE CHARGE WILL BE APPLICABLE TO THE
CUSTOMER OF LABOUR AT
$120.00 Call out fee including first 30
min + GST then $45 per 30min,
PLUS TRAVELING
EXPENSES.
!
