Aurora Multimedia DIDO LT, Installation Manual

Page: 27 / 44

DIDO LT Installation Manual
26
8 Troubleshooting
Symptom Checks
Key on remote is pressed but
nothing happens Check to see if the batteries are good. If the batteries are
good – check the cable connections between the Plasma
Display and the DIDO LT Also, make certain the DIDO LT
has power.
Check if the IR remote address is the same as the DIDO
LT’s address in System Setup menu.
The display does not turn on or
show an image Check to see if the OSD from the DIDO LT displays. If it
does check the source selection and/or cables for the
source. If there is no OSD then make certain the output
cable is connected properly and the output timing of the
DIDO LT matches the capabilities of the display device.
Make sure the DIDO LT is not in standby.
No control via RS-232
connection to DIDO LT Check cable connection. If connection is ok, check baud
rate and address of DIDO LT
DVI output has horizontal noise
going across intermittently This could happen if a DVI cable is too long. Typical DVI
should not exceed 6ft. Some after market products can
enhance the length of DVI. Double check the specifications
before using these types of DVD cables.
Video is black and white Under Input Settings, check the selection for the SVID. If
the video sync is weak try using video selection instead of
Auto. Also, make certain it is not set for S-Video.
S-Video does not lock Under Input Settings check the selection for the SVID.
Make certain the selection is not set for Video.
DVI has output but RGB does
not If the content has HDCP, the RGB/YPbPr output will be
disabled due to copyright protection. If it is not HDCP
protected, heck the Output Setup to make certain RGB is
not disabled.
No image on either output Check output resolution is compatible with display device
and the DIDO LT is not in standby mode.
Image is green on the input Make certain the DIDO LT input for RGB/YPbPr is set up
correctly.
Image is green on the output If the output of the DIDO LT is setup incorrectly (RGBHV vs
YPbPr vs RGsB) it may result in a green image.
Tri Mode does not work DIDO LT does not have this feature. Must use regular
DIDO if this feature is desired.
Quad Mode does not work DIDO LT does not have this feature. Must use regular
DIDO if this feature is desired.
Side B input keys do not work DIDO LT does not have the additional inputs. Must use
regular DIDO if this feature is desired.