11.
AUMA CDT software (accessories)
The AUMA CDT software (accessories) can be used to establish a connection to a
computer (PC, laptop or PDA).
It can be downloaded free of charge from our web site www.auma.com.
Figure 27: Connection with service cable
For connecting the computer to the integral actuator controls, a service cable (AUMA
article no.: Z100.999) is required.
Read/perform basic settings via AUMA CDT
Basic settings at the device (in controls) made via switches are read only via AUMA
CDT on delivery and cannot be modified. To be able to change these parameters
via software, position switch [S5] in controls to "Software mode". Refer to <Settings
via hardware (switches) or via software> chapter.
Switches and software parameters are set to the same values upon delivery (factory
settings).
Further settings via AUMA CDT
Apart from basic settings, the following functions may additionally be set via AUMA
CDT software:
●
Torque by-pass
Allows suspending torque monitoring at actuator start-up. Duration for torque
by-pass is adjustable.
●
Electronic positioner (option)
●
Failure behaviour (on loss of signal)
●
EMERGENCY behaviour (option)
●
Timer function (option)
●
Motion detector
●
Type of duty monitoring (motor starts and running time)
●
Operating time monitoring
●
Self-retaining local
For detailed information on these functions, refer to the online help of the AUMA
CDT software.
40
SVC 05.1 – SVC 07.5/ SVCR 05.1 – SVCR 07.5
AUMA CDT software (accessories)
