7.
Indications
7.1.
Status indications in the display
Status indications regarding faults and warnings, refer to page 58 et seqq.
7.1.1 Status indication S0/S6 - operation
Information
For actuators equipped with process controllers, status indication
S6
is dis-
played instead of status indication
S0
.The description below applies to both
indications (
S0
and
S6
).
Operation mode display
Line 1 indicates the current operation mode
(LOCAL MODE, OFF, SETPOINT MODE, …)
Operation command/
setpoint display
Line 2 indicates currently incoming operation commands
(OPEN, STOP, CLOSE) or the setpoints E1 or E7 (for actuators equipped
with positioner/process controller) in % of the total travel.
Valve position display
Line 3 indicates the valve position in % of the travel.
This indication is only available if the actuator is equipped with a position
transmitter.
0 % = Actuator is in end position CLOSED
100 % = Actuator is in end position OPEN
End position/running indication
Line 4 indicates the current actuator status.
È
Description of indications in line 4:
RUNNING OPEN
Actuator runs logically OPEN (remains set during operation pauses).
RUNNING CLOSE
Actuator runs logically CLOSE (remains set during operation pauses).
OPEN POSITION
End position OPEN reached.
34
Multi-turn actuator SAExC 07.1 – SAExC 16.1/SARExC 07.1 – SARExC 16.1 Non-Intrusive
with actuator controls AUMATIC ACExC 01.1 Profibus DP
Operation instructions
LOCAL MODE
S0
OPEN
E2
100 %
RUNNING OPEN
LOCAL MODE
S0
OPEN
E2
100 %
RUNNING OPEN
LOCAL MODE
S0
OPEN
E2
100%
RUNNING OPEN
LOCAL MODE
S0
OPEN
E2
100%
RUNNING OPEN
