Audinate Dante MY16-AUD, User Manual, Page: 3 / 58

Dante-MY16-AUD2 User Guide
Copyright © 2016 Audinate Pty Ltd. All rights reserved.
-3-
Dante-MY16-AUD2: Use of 100Mbps Network interface 28
HA Remote 29
HA Remote Chain Example 1 29
HA Remote Chain Example 2 30
Mode Selection 30
Available HA Remote Modes 31
Product / Mode matrix 32
Special Considerations 32
Basic Operation 33
Pre-operation checklist 33
Using Dante Controller 33
Setting up audio routes 34
Configuring your Card 34
Identifying individual Dante-MY16-AUD2 cards 35
Dante-MY16-AUD2 Device Name 36
Dante-MY16-AUD2 Default Sample Rate 36
Pull-up/down 36
AES67 Config 36
Advanced Configuration with Dante Controller 38
Unicast and Multicast Modes 38
AES67 Flow 39
Setting Latency 40
Configuring the Dante-MY16-AUD2clock 40
Master Clock 41
Checking clock configuration 42
Configuring your Yamaha Equipment 43
Upgrading Firmware 44
Troubleshooting 45
Introduction 45
Network Configuration – Gigabit Ethernet 45
What are the symptoms of NOT using Gigabit Ethernet? 45
How can I check whether I AM using Gigabit Ethernet? 46
Switch Configuration and Cabling 46
Computer Configuration 47
Dante Configuration: Sample Rate 47
Common configuration issues 47
Symptom: Audio only appears on every second channel @ 88.2kHz or 96kHz 48
Dante Configuration: Clock 48
How do I know if my clock is incorrectly configured? 48
How do I fix it? 48
Symptom: Orange ‘Error’ light with green ‘Sync’ light 48