Dante-MY16-AUD2 User Guide
Copyright © 2016 Audinate Pty Ltd. All rights reserved.
-33-
Basic Operation
Once you have installed Dante-MY16-AUD2 cards in your Yamaha equipment and connected them to a
network you are in a position to start using Dante networking in earnest to set up audio routes between
devices, including other Dante-enabled devices you may have on the network and any computers running
Dante Virtual Soundcard or Dante Via.
Pre-operation checklist
To start configuring and using your Dante-MY16-AUD2 card and Audinate software you should have
completed the following:
n
Installed your Dante-MY16-AUD2 card in your Yamaha equipment
n
Redeemed your DVS Token for a Dante Virtual Soundcard License ID
n
Downloaded and installed your Audinate software
n
Set up a network between your PC or Mac and your Dante-MY16-AUD2 card(s)
n
Referred to the Dante Controller and Dante Virtual Soundcard User Guides
Using Dante Controller
When you open Dante Controller it displays a grid view, which shows all the Dante-enabled devices on the
network. Initially it will display devices, but not channels within devices. Devices with transmitter (Tx)
channels will be displayed along the top row and devices with receiver (Rx) channels will be displayed in
the left hand column Channels can be viewed by clicking on the + symbol next to Dante Transmitters or
Dante Receivers, or the + symbol next to a particular Dante device.
Note: The
contains detailed information about all aspects of using
Dante Controller. This section is only a brief overview – you will need to refer to the User Guide to be
able to use all features of Dante Controller.