Au Group Electronics
Au SAE J1939 Simulator (Gen II) 2.00A User Manual Rev. D
16
Figure 4-5 shows the J1939 Simulator Remote Terminal for
Engine Basic
Plus
edition. Engine Idle Shutdown (IS),
Engine Protection System (EPS), A/C & Refrigerant Switch, Engine Info, Cruise lamps, and Engine Basic Parameters
are active.
ABS info and Warning Lamps, Transmission Info and Warning Lamps, Engine DM1, Engine DM2, Engine Configuration,
ABS DM1, Transmission DM1 are
not
available.
Figure 4-5
Au J1939 Simulator Remote Terminal GUI – Engine Basic Plus
Following paragraphs will explain how to use the GUI remote-control of the J1939 Simulator Gen II 2.00A
Plus
editions.
4.1.
Step 1: Connect To J1939 Simulator
Connect the simulator to power supply and a CAN network, and then connect it to a PC serial port.
Select serial port from the "Port" drop down list
Æ
click "Connect" button
Æ
Product information of the connected J1939
simulator device will display (Product ID, Simulator Version (firmware), and serial number), as shown in Figure 4-6.
Figure 4-6
J1939 simulator remote terminal control panel step
Note
: The control panel step 1 can always be used to display Product ID, Simulator Version, and Product Serial
Number for all Au J1939 simulator Editions (both
plus
edition and
non-plus
edition).
The function of step 1 control items is summarized in Table 4-1.
