Atrie DB-120 WL User Manual
Page 14 / 25
3.4.8 MODIFY AN EXISTING CONNECTION
To modify an existing connection, from the Home screen, click setup and then click the connection you
want to modify. The connections are listed as its name.
As a note, if you delete the connection, to make the change permanent you need to click
"Save All"
in
"System commands"
.
3.5 WIRELESS CONFIGURATION
Press “
WIRELESS
” on the top of web pages to enter wireless section. You can select to configure
wireless setup, security and management.
3.5.1 WIRELESS SETUP
Click “
Setup
” on the left menu to setup basic wireless parameters. In default, check “Enable AP” box to
launch wireless AP.
z
SSID (
Service Set Identifier): The mobile users cannot access WLAN until setting their SSID as the same
value of the wireless ADSL. The SSID value of the ADSL is “default”
z
Hidden SSID:
If checked, wireless station will no see SSID of the ADSL.
z
Channel B&G
：
To denote the different frequency of wireless signals whose value is from 1 to 11. The
default value is”11”. If there are more than one APs located in the same area, each of them must works at
different channels to reduce interference. For Example: Three APs are install in the same place, the AP’s
channel should be 1,6 and 11 respectively.
z
802.11 Mode:
You can select one of “B only”(802.11b only), “B+”(802.11b+), “G only”(802.11g) or
“Mixed”. If “Mixed” selected, the wireless router will adapt itself to wireless station.
z
User Isolation:
If checked, the mobile users can’t see and access each other by network neighbor.
Figure 3.8 (Wireless Setup)
