Atrie DB-120 WL User Manual
Page 20 / 25
4 OTHER CONFIGURATION
4.1 LAN CONFIGURATION
4.1.1 CONFIGUR GATEWAY’S IP ADDRESS
As a network device, the Gateway has its own IP address. The factory sets the MODEM, at a default IP
address of 192.168.1.1 and subnet mask of 255.255.255.0. The user can configure they in "LAN Setup".
For example, to change IP address to "10.10.10.10". Click "LAN Setup", choice "Use the following
Static IP address", then input "10.10.10.10" in "IP address" and "255.0.0.0" in "subnet mask". The result is
shown as Figure4.1, press "Apply".
Figure 4.1
Notes: When the IP address have be changed, it will take effect immediately. Then you maybe cannot access
the WEB-UI.
Please wait about 30 seconds, and then access the WEB-UI by the new IP address.
4.1.2 DHCP CONFIGURATION
The user can configure the DHCP mode in "LAN Setup".
1.
To Enable the DCHP Server mode, choice "Enable DHCP Server" and fill in the following textbox.
The "Start IP" is where the DHCP server starts issuing IP addresses. This value must be greater than the
Gateway’s IP address value. For example if the Gateways IP address is 192.168.1.1 (default) than the starting
IP address must be 192.168.1.2 (or higher).
The "End IP" is where the DHCP server stops issuing IP addresses. The ending address cannot exceed a
subnet limit of 254. Hence the max value for our default Gateway is 192.168.1.254. If the DHCP server runs
out of DHCP addresses, users will not get access to network resources. If this happens you can increase the
Ending IP address (to the limit of 255) or reduce the lease time.
The "Lease Time" is the amount of time a network user will be allowed connection to the Router with their
