83
Figure 2.95 Example of Switch B’s RAPS VLAN setting
7.
Connect Switch A’s Port 7 to Switch B’s Port 8. Connect Switch A’s Port 8 to Switch B’s Port 7
(like cross-over) for the redundancy port.
8.
If everything is setup properly, you will find Switch A to have the following ERPS state. It will
automatically block Port 8 to prevent a network loop.
Figure 2.96 Switch A’s ERPS state
9.
Now you can add any other bridge that you want in between the two managed switches.
2.15.3
iA-Ring Setting
Atop’s managed switch is designed to be compatible with iA-Ring protocol for providing better network
reliability and faster recovery time for redundant ring topologies. It is in the same category as R Rings,
but with its own protocol. It has been a successful development that reduces recovery time to less
than 20 ms. iA-Ring can be used for any single ring, which is shown in the diagram below (
Figure
2.97).
Summary of Contents for EH7506
