82
UERPS Settings (optional)
1.
Prepare two managed switches (Switch A and Switch B). We will use Port 7 and Port 8 on both
switches for redundancy.
2.
Connect Switch A and Switch B to the network or PC so that you can access them. For simplicity
you can use Port 1 for Web configuration on both switches.
3.
Open SwitchView (Management Utility) and change the IP address of Switch B or both switches.
The IP addresses won’t be conflicting.
4.
Open Switch A and B’s WebUI and setup ERPS settings like the following. You just need to
enable ERPS, Log, and UERPS. You need to press “Update” for the changes to take effect.
Figure 2.93 Example of Switch A’s ERPS settings
5.
On Switch A, Click “Configure” on RAPS VLAN and setup as the below figure.
Figure 2.94 Example of Switch A’s RAPS VLAN settings
6.
Open Switch B’s WebUI and setup ERPS settings like the following.
Summary of Contents for EH7506
