Atlas APEX-10, Installation & Operation Manual

Page: 54 / 75

Additional Information 54 Apex-10 / Apex-10H
Operating Instructions
Please reference enclosed ANSI/ALI ALOIM – Current Edition and ALI/LP Guide
before proceeding.
1. Ensure lift is fully lowered and service bay is clear.
2. Move swing arms to full drive thru position.
3. Center the vehicle between the lift posts and position the arms in
accordance with the supplied “Lifting it Right” and “Lifting Point” guides. Be
sure you are using the proper adapters.
4. Push the raise switch on the power unit and ensure that the arm restraint
pins for engagement.
5. Raise the vehicle until the suspension and tires clear the fl oor.
6. Stop and check the adapters for secure contact in accordance with the
vehicle manufacturer recommended lifting points and “Lifting Point” guide.
7. Moderately shake vehicle by pushing on the front or rear bumper to ensure
that vehicle is safely positioned on the lift.
8. After confi rmation that vehicle is securely positioned, continue to raise the
lift to the desired lift height.
9. Lower the lift onto the mechanical locking latches.
10. Avoid excessive rocking of the vehicle while it on the lift.
11. Always use safety support stands when removing or installing heavy vehicle
components.
12. To lower the lift, fi rst be sure that all objects and all personnel are free from
lift area. Observe pinch point and other warning decals.
13. Raise the lift off the locking latches.
14. Pull down and hold the safety release while pressing the hydraulic lowering
valve handle until the lift has fully lowered to the ground and the arm
restraints have disengaged.
15. Remove adapters and position arms in full drive thru position before
removing vehicle from the service bay.