Installation
37
Apex-10 / Apex-10H
• Bring the cable down inside the off-side column and feed the end of the
cable through the lower slot (ref. fi g. 22);
• Install the cable pulley in the lower slot of the off-side column (ref. fi g. 22);
• Route the cable under the bottom side of the pulley (ref. fi g. 22);
• Insert the cable in the cable clamp along one side, loop around the
shoulder bolt and back down and insert the cable along another side of the
cable clamp (ref. fi g. 22). Slightly tighten the clamp;
• Press the safety release lever down to eliminate any clearance between the
slots and pins;
• Using the pliers, pull the cable tight and secure the clamp close to the
shoulder bolt. Tighten the clamp;
• Install the safety release lever and ABS plate using the nuts M22 (ref. fi g,
19). Install the ABS cover using the cross recess head screw M8X10 and
the washers D.10 and then install the lever ball on the lever (ref. fi g. 23).
Shoulder bolt
ABS cover
Cable clamp
Lever ball
Pulley
Figure 23
Figure 22
Summary of Contents for APEX-10
