Additional Information
53
Apex-10 / Apex-10H
Operation Test with Vehicle
Prior to starting this section, please refer to the important safety instructions at
the beginning of this manual. Reference Automotive Lift-Safety Requirements for
Operation, Inspection, and Maintenance (ANSI/ALI ALOIM)
After fi nishing the above assembly instructions and adjustments, perform an
operation test of the lift using a typical vehicle.
1. Lower lift to ground.
2. Drive vehicle on to lift and position the arms as per the “Lift it Right” manual
and “Lifting Points Quick Reference” guide.
3. Raise lift to and lower onto 3-4 lock positions during full rise to ensure all
locks are working correctly.
4. Re-adjust cables if necessary while vehicle is on.
5. Check lowering speed and smooth decent rate.
6. Lower lift to ground and drive vehicle off lift.
Run the lift in the low position several times, and then run the lift to the top
completely.
If any problems occur during the fi nal checkout or operation test
of the lift with a vehicle, please contact your lift distributor, sales
representative or manufacturer immediately.
Summary of Contents for APEX-10
