Installation
26
PVL14OF-EXT
Make sure each cable is routed in the pulley groove following
the roping diagram fi g. 14. Failure to install the nylon bearings
and bearings in the runways and beams will result in premature
failure and void the warranty.
7.8
Attaching Front Columns To Front Beams
• Position front columns to the rear corner of the lift.
• Place the latch rack into the back of
the column. Pay attention that the
latch rack is offset from the center
line of the thread stud. It should
be oriented toward the back of the
column from the center line of the
thread stud.
• Secure the bottom of the latch rack to
the column as shown in fi g.20.
• Install the top plate onto the column
using screws as shown in fi g.21.
Tighten the screws and nuts.
• Insert the thread stud of the latch
rack through the hole of the top plate
and fi t two M20 nuts into the thread
stud of the latch rack. Adjust the nuts
down the thread stud until the nut
and the top plate are fl ush.
• Lay the column down with back to the fl oor.
