B. CREEPING INTERMEDIATE PRESSURE:
POSSIBLE CAUSE
RECOMMENDED ACTION
Damaged or worn 1st
stage
Replace 1st stage
C. HISSING FROM SECOND STAGE (but intermediate pressure is OK):
POSSIBLE CAUSE
RECOMMENDED ACTION
Damaged or worn 2nd stage LP seat
(16)
Replace LP seat
Nicked orifice (22) sealing surfaces
Replace orifice
2nd stage demand lever (20) bent too
high
Replace lever
Worn O-ring (21) on orifice (22)
Replace O-ring
Worn O-ring groove on orifice (22)
Replace orifice
Orifice (22) out of adjustment
Adjust orifice
D. WET BREATHING:
POSSIBLE CAUSE
RECOMMENDED ACTION
Diaphragm improperly installed or
hole in diaphragm
Check position of diaphragm visually.
Replace if holes found by holding up to
a light.
Damaged or loose fitting exhaust
valve
Replace exhaust valve (4)
Crack in housing (3)
Replace housing
Worn O-rings (17,24,11)
Replace O-rings (17,24,11)
Scratched or worn bushing (25)
sealing surfaces
Replace bushing (25)
Scratched or worn housing (3)
sealing surfaces
Replace housing
Improper clearing techniques by
diver
Instruct diver on clearing techniques
Extremely slow breathing
allowing water to build up in
housing rather than being blown
out
Explain this result of slow breathing to
diver.
Summary of Contents for Splash Tech R60 2nd Stage
Page 1: ...2nd Tech R60 2nd Stage Service Manual TECH R60 2nd STAGE...
Page 14: ...Remove the DIAPHRAGM WASHER 7 and the diaphragm 6 from the housing 3...
Page 29: ...Install a new well lubricated O ring 11 onto the ADJUST KNOB 10...
Page 39: ...Re check work of breathing Replace mouthpiece with cable tie...