Before removing the exhaust valve (4) from the housing (3), bend the valve over as far as it
will go from the top, bottom, left, and right sides. If it fails to snap back quickly, and does not
lie perfectly flat against the housing exhaust grid, the valve should be replaced. If it does snap
back satisfactorily, remove it by pulling it out with your fingers. Inspect the sealing edges. If
they appear smooth, and the locking tab on the nipple is good, the valve can be reused.
Summary of Contents for Splash Tech R60 2nd Stage
Page 1: ...2nd Tech R60 2nd Stage Service Manual TECH R60 2nd STAGE...
Page 14: ...Remove the DIAPHRAGM WASHER 7 and the diaphragm 6 from the housing 3...
Page 29: ...Install a new well lubricated O ring 11 onto the ADJUST KNOB 10...
Page 39: ...Re check work of breathing Replace mouthpiece with cable tie...
