Insert the ADJUST KNOB (10) into the inlet tube over the poppet assembly you just installed.
Turn the ADJUST KNOB (10) clockwise until the O-ring and flange have passed the hole where
the pin (19) is installed.
Install the pin (19) into the inlet tube (18).
Back the ADJUST KNOB (10) out until it tightens against the pin (19), holding it in place.
Summary of Contents for Splash Tech R60 2nd Stage
Page 1: ...2nd Tech R60 2nd Stage Service Manual TECH R60 2nd STAGE...
Page 14: ...Remove the DIAPHRAGM WASHER 7 and the diaphragm 6 from the housing 3...
Page 29: ...Install a new well lubricated O ring 11 onto the ADJUST KNOB 10...
Page 39: ...Re check work of breathing Replace mouthpiece with cable tie...
