Insert the poppet assembly. Push the assembly all of the way into the inlet tube. The first
thing that might hang up on the tabs of the lever is the LP seat.
Wiggle the lever to get this past the tabs. When the “¬” shaped feet get to the lever tabs
they will lift the lever inwards as you push the assembly in. Insert the poppet assembly you
have just assembled, into the inlet tube (18) at the end with the raised collar (opposite the
external threaded end).
When the poppet assembly is inserted into the inlet tube, it is important that the “L” shaped
foot on the poppet section engages properly with the lever tabs that extend through the holes
in the inlet tube.
Summary of Contents for Splash Tech R60 2nd Stage
Page 1: ...2nd Tech R60 2nd Stage Service Manual TECH R60 2nd STAGE...
Page 14: ...Remove the DIAPHRAGM WASHER 7 and the diaphragm 6 from the housing 3...
Page 29: ...Install a new well lubricated O ring 11 onto the ADJUST KNOB 10...
Page 39: ...Re check work of breathing Replace mouthpiece with cable tie...
