3
AS
SEMBL
Y
INSTRUC
TIONS
9/16” (14 mm)
wrench or
crescent wrench
The tools listed above are required to install weight stacks, remove pads and disassemble any
Atlantis bolt combination. Bolts need to be removed with impact driver or ratchet fitted with 9/16”
(14 mm) socket and 9/16” (14 mm) wrench or crescent wrench. Be sure to re-install all bolts and
washer’s combinations in the same order they were removed. Atlantis strongly recommends at least
two people perform the following procedures for safety and comfort.
WARNING: Please note that shipping units (even over very short distances) can
loosen the tightest of bolts. It is therefore extremely important that all bolts be
carefully tightened before any equipment is used and on a regular basis thereafter.
The required tools for assembly are:
1
Assembly instructions
Impact driver or ratchet
socket wrench fitted with
9/16” (14 mm) socket
