ATEN SN0108A, User Manual

Page: 121 / 172

Chapter 8. Device Management
105
Š
Use the same Group name on both the RADIUS server and the
Serial Console Server.
Š
Use the same Username/Group name on both the RADIUS server
and the Serial Console Server.
In each case, the user’s access rights are the ones assigned that were
assigned when the User of Group was created on the Serial Console
Server. (See
Adding Users , page 78.)
Š
LDAP / LDAPS Authentication and Authorization Settings
To allow authentication and authorization for the Serial Console Server via
LDAP / LDAPS, refer to the information in the table, below:
Item Action
Enable Put a check in the Enable LDAP or Enable LDAPs checkbox to
allow LDAP / LDAPS authentication and authorization.
LDAP Server IP
and LDAP
Service Port Fill in the IP address and port number for the LDAP or LDAPS
server.
Š
You can use the IPv4 address, the IPv6 address or the
domain name in the
LDAP Server field.
Š
For LDAP, the default port number is 389; for LDAPS, the
default port number is 636.
Alternate LDAP
Server and
Alternate LDAP
Service Port Fill in the IP address and port number for the alternate LDAP or
LDAPS server.
Š
You can use the IPv4 address, the IPv6 address or the
domain name in the
Alternate LDAP Server field.
Š
For an Alternate LDAP Service Port, the default port number
is 389; for an Alternate LDAPS Service Port , the default port
number is 636.
Admin DN Consult the LDAP / LDAPS administrator to ascertain the
appropriate entry for this field. For example, the entry might
look like this:
ou=kn4132,dc=aten,dc=com
Admin Name Key in the LDAP administrator’s username.
Admin Password Key in the LDAP administrator’s password.
Search DN Set the distinguished name of the search base. This is the
domain name where the search starts for user names.
Timeout
Set the time in seconds that the Serial Console Server waits for
an LDAP or LDAPS server reply before it times out.