ATEN CM1164A, User Manual

Page: 23 / 152

Chapter 1. Introduction
11
IR Remote Control
No. Component Description
1 OSD button Press this button to turn on or turn off the OSD Menu.
When the OSD Menu is enabled, press the OSD button to
go back to the previous menu / submenu.
2 Fn1 / Fn2 / Fn3 /
Fn4 buttons and
select button
Use these buttons to switch between Function modes (Fn1
to Fn4), and to cycle through the OSD Menu/selection.
See Configuring the Display Aspect Ratio , page 54 for
details on how to store function mode settings, which you
can invoke for later use.
The Fn1~Fn4 buttons are positioned to correspond to the
up / down / left / right direction.

When cycling through the menu options, press the Select
button to go the submenu.

If you want to change or adjust a selection/value, press
the Select button then the Fn1 (up) / Fn2 (left) / Fn3
(down) / Fn4 (right) buttons to go through all the
selections/values. Press the Select button again to
confirm a selection.
3 display mode
buttons
Select the display mode you want to view. See Extended
Desktops , page 37.
4 KVM port selection
buttons 1~4

Press these buttons to switch ports (1~4).

In a cascade setup, press these buttons to switch the
console display to the corresponding secondary
KVMP
TM
Switch.
2
5
3
4
1