ATB AQUAmax PROFESSIONAL G, Installation Instruction, Operating And Maintenance Manual, Page: 24 / 56

Installation, operating and maintenance manual AQUAmax
®
PROFESSIONAL G
ATB WATER GmbH, Südstraße 2, D-32457 Porta Westfalica, www.atbwater.com /
Art.-Nr.: 9060 XXXX / Stand: 08.01.2019 / Seite 24 von 56
Equipment characteristics
•
Controlled by microprocessor
•
Protection marking for electrical enclosures IP54
•
Wall mounting
•
Undervoltage failure signalling (UVS)
•
2 potential-free contacts for alarm facility
•
Activation of a dosing pump for phosphate removal
•
Activation of a UV-system for disinfection
•
Comprehensive logbook documentation
•
Simple and rapid handling by 4 softkey operation
•
Times for all parameters completely pre-programmed
•
Automatic run-in phase with suppression of the excess sludge removal
•
Parameter settings freely selectable
•
Selection of 6 menu languages (German, English, French, Spanish, Rumanian and
Polish)
•
Can be used for AQUA
max
® BASIC, CLASSIC and PROFESSIONAL
•
Ready-to-connect version for BASIC, CLASSIC und PROFESSIONAL G
•
Following power failure (< 30 min) restart at the interrupted program point
•
Wide range power supply 110 – 250V, 50/60Hz
Assembly
Using the mounting material provided, secure the pro
Control
©
2 to the cabinet brackets
provided and at a suitable position, as far as possible not directly affected by weather
conditions.
With temperatures below 0°C one has to reckon with a severely limited function of the LC
display.
The pro
Control
©
2 is delivered as ready-to-connect model for the variants CLASSIC, BASIC
and PROFESSIONAL G. Installation wiring in situ is dispensed with!
For the PROFESSIONAL XL the control unit is wired complete, with a separate connection,
to a common assembly plate. Opening of the control unit is dispensed with! An associated
connection plan is provided.
For the AQUAmax® PROFESSIONAL GZB
with pressure aeration, the control unit is
already mounted on a mounting plate. This
can be mounted directly on the wall or in an
outdoor control cabinet.
Next to the control unit there is a distribution
box on the mounting plate to which the
excess sludge pump is connected, as well
as the sockets for the control unit (and the
mains supply line) and the compressor(s).
The remaining units and float switches are
connected directly to the control unit (see
pin assignment on the previous page).