Operating instructions AQUAMAX
®
PRO G
ATB WATER GmbH, Südstraße 2, D-32457 Porta Westfalica, www.atbwater.com /
Art.-No.: 9060 0272 / Status: 24 February 2021 / Page 16 from 36
Service mode
In the “service mode” all relevant and necessary operating parameters for
the wastewater treatment plant can be changed. Please note that incorrect
settings can cause a faulty operation!
Access to the service mode via a 6 - digit code number, which is made
available exclusively to authorized service specialists.
For entries that cause the nitrification phase to
last < 30 min, the previous parameter set is
automatically set.
After a parameter change the cycle starts with the last deni-phase
before the settling phase.
Other inputs are not checked for plausibility!
In this case ATB WATER GmbH excludes any warranty!
The individual parameters are presented to you on the following pages. If
you have questions, please contact us at any time!
When exiting the service mode, the program continues at the same point, as
before the entry.
Plant type
Select the plant type.
PT number
Entering the PT number will automatically load the default parameter set for
this size. This means that, as a rule you need to carry out no further actions.
The pre-set parameters for the individual dimensions are given in the
appendix.
Operating parameters
To enter and to change relevant parameters.
The data displayed under "Info" result from the
entries and can only be changed indirectly.
.
S
S
E
E
R
R
V
V
I
I
C
C
E
E
M
M
O
O
D
D
E
E