Installation & Servicing instructions ATAG iC-Range
60
14 Parameter chapter
When the boiler is installed, it is in principle ready to be put into service. Most settings of the control system
are already programmed from factory.
To change this setting, proceed as follows:
14.1 Change the settings
The settings are accessable through a code.
1
From the controller Home screen, press the
BACK
and
OK
buttons at the
same time for 7 seconds.
2
Turn the selector wheel to highlight
007
as the Technical Code.
Press
Save
.
The screen left appears.
3
Turn the selector wheel to highlight
Complete Menu
.
Press
OK
.
It takes a while to load the Menu
The screen left appears.
This way you have access to the complete parameter level.
