Asus KFN5-Q - Motherboard - nForce Pro 3600, User Manual, Page: 54 / 175

ASUS KFN5-Q Series 2-33
3. SAS LSI1068 ports LED connector (18-1 pin SASLED1)
( For KFN5-Q/SAS model only)
This connector is for SAS link state’s LED. The active LOW Fault LED
signals are nominally configured to indicate a SAS link fault for each
respective phy. The active LOW Activity LED signals are nominally
configured to indicate SAS link activity.
• Pin 20 on the IDE connector is removed to match the covered hole
on the Ultra DMA cable connector. This prevents incorrect insertion
when you connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE
devices.
If any device jumper is set as “Cable-Select,” make sure all other device
jumpers have the same setting.
Drive jumper
setting
Mode Cable of
device(s)
Cable connector
Single device Cable-Select or
Master
- Black
Two devices Cable-Select Master
Slave
Black
Gray
Master
Slave
Master
Slave
Black or gray
KFN5-Q/SAS
KFN5-Q Series SASLED Connector
SASLED1