32
Chapter 4 - Configuration Management
ASUS GigaX 1024i+
matches the Oid in the SNMPv3 message.
•
View Subtree
: Enter the View Subtree that the View belongs to. The
Subtree is the Oid to match the Oid in the SNMPv3 message. The match
is good when the subtree is shorter than the Oid in the SNMPv3 message.
•
View Mask
: Enter the View Mask that the View belongs to. Each bit in
the mask represents the digit between the dots of View Subtree from left
side. Bit ‘0’ means ‘nothing’.
Click <
Add
> to create a new VACM View entry. To remove an existing
entry, select the view and click <
Remove
>. To update an existing entry,
select the view and click <
Modify
>. Click <
OK
> to save the changes on
this page. Click <
Reload
> to refresh the settings. To permanently save the
new configuration, go to the
Save Configuration
page, then click <
Save
>.
4.4.6 USM User
USM (User-based Security Model)
User
is used to configure the
information of SNMPV3 USM User.
The USM User page has the
following parameters:
•
Engine Id
: Enter the Engine Id that
matches the ID in the Manager.
•
Name
: Enter Name combined with Engine ID that should match the
Name and Engine ID in the Manager.
•
Auth Protocol
: Enter the Auth Protocol that Engine ID and Name belong
to. Only NoAuth, MD5, SHA1 can be chosen. If the NoAuth is chosen,
there is no need to enter the password.
•
Auth Password
: Enter the password that the Auth Protocol belongs to.
The password needs at least 8 characters or digits.
•
Priv Protocol
: Enter the Priv Protocol that Engine ID and Name belong
to. Only NoPriv ,DES can be chosen. If the NoPriv is chosen, there is no
need to enter password.
•
Priv Password
: Enter the password that the Priv Protocol belongs to.
The password needs at least 8 characters or digits.
Click <
Add
> to create a new USM User entry. To remove an existing
entry, select the entry and click <
Remove
>. To update an existing entry,
select the entry and click <
Modify
>. Click <
OK
> to save the changes on
this page. Click <
Reload
> to refresh the settings. To permanently save the
new configuration, go to the
Save Configuration
page, then click <
Save
>.
Figure 34. USM User
