31
Chapter 4 - Configuration Management
ASUS GigaX 1024i+
4.4.4 VACM Group
VACM (View-based Access Control
Model) Group
is used to configure
the information of SNMPV3 VACM
Group.
The VACM Group page has the
following configuration parameters:
•
Group Name
: Enter the security
group name.
•
Read View Name
: Enter the Read
View Name that the Group belongs to. The related SNMP messages are
Get, GetNext, GetBulk.
•
Write View Name
: Enter the Write View Name that the Group belongs to.
The related SNMP message is Set.
•
Notify View Name
: Enter the Notify View Name that the Group belongs
to. The related SNMP messages are Trap, Report.
•
Security Model
: Enter the Security Model Name that the Group belongs
to. Any is suitable for v1,v2,v3. USM is SNMPv3 related.
•
Security level
: Enter the Security level Name that the Group belongs to.
Only NoAuth, AuthNopriv, AuthPriv can be chosen.
Click <
Add
> to create a new VACM group. To remove an existing VACM
Group, select the group and click <
Remove
>. To update an existing entry,
select the group and click <
Modify
>. Click <
OK
> to save the changes on
this page. Click <
Reload
> to refresh the settings. To permanently save the
new configuration, go to the
Save Configuration
page, then click <
Save
>.
4.4.5 VACM View
VA C M ( Vi e w - b a s e d A c c e s s
Control Model) View
is used to view
the information of SNMPV3 VACM
Group.
The VACM View has the following
parameters:
•
View Name
: Enter the security
group name.
•
View Type
: Select the View
Type that the View belongs to. Included or Excluded when View Subtree
Figure 32. VACM Group
Figure 33. VACM View
