8
TOPIC
DEFAULT FEATURES FOR STAGE 2
LEVEL
Accessory output
Relay
• Accessory
Level 1
Page 23
Parking Light
output Relay
• Parking Light
Level 2
Page 23
Miscellaneous
Configurations
• Start confirmation on demand: Enable
• 2
nd
Lock confirmation on Horn output
• Turbo Mode: Disable
• Dome light activation when engine stops (with key): Disable
Level 3
Page 23
Miscellaneous
Configurations
(2
nd
Part)
• P9 LED output indicates the status of: Alarm, Antitheft and Manual Sequence
Level 4
Page 23
IMPORTANT NOTE TO BE READ AT THE INSTALLATION
-
The remote starter control module is
FACTORY PROGRAMMED FOR MANUAL TRANSMISSION
VEHICLE
. Be sure to program it for the right type of vehicle you’re working on.
-
The
ALARM
portion is factory programmed Disable. It needs to be set to Enable for it to work properly.
-
When the Alarm part of the control module is enabled, the White and Purple wires (P1-6 and P1-7),
used to monitor the doors,
NEED TO BE BOTH CONNECTED
, no matter which polarity the dome light
circuit is powered up. This type of connection is compatible with all switching types and will support anti-
battery-depletion functions found in newer vehicles.
-
If the « Alarm Link » option is used, the White and the Purple are now used to detect the OEM alarm
horn. Remember
; both the Purple and the White wires (P1-6 and P1-7) need to be hooked up
to
detect the horn properly.
CONTROL MODULE PROGRAMMING
Two different methods can be used to program our remote starters:
-
The Multitest II tool:
The Multitest II (part no. 310-059-501) is an indispensable tool that was designed to help improve
installers’ time and efficiency when it comes to programming the control unit options or diagnose a hard
to find intermittent remote starter or alarm problem.
This tool communicates through the receiver (antenna) cable, so no access to the unit under the
dashboard is required. Visit our web site at
www.astroflex.com
for more details.
-
By the « DIP » switches:
With its sophisticated processor, and its multiple programming levels, AstroStart control module allows
direct entry into a multitude of programming options with little effort. You only need to find the Level
where the option is and program that level. If you don’t own a Multitest II tool and some modifications in
the default programming need to be done, go to the « Programming Tables » on page 17 of this guide.
Summary of Contents for BBF
Page 30: ...28...
