AstroStart BBF, Installation Manual

Page: 8 / 30

6
P4 CONNECTOR
PIN COLOR DESCRPTION PURPOSE
1
Red/Black Power Input
+12V power input, protected by a 30A fuse (F1)
Supplies "Accessory-Yellow Wire" and the "Starter-Dark Blue Wire".
2
Yellow
Accessory
Output (+)
Feeds vehicle accessory circuit (Heater / AC circuit).
This output can be program differently in Stage 2 – Level 1, page 23.
See page 12 for more details about this output.
3
Green
Parking lights
Output (+)
Protected by a 10A fuse (F3), used to supply parking light circuit.
This output can be program differently in Stage 2 – Level 3, page 23.
See page 13 for more details about this output.
4
Orange
Ignition
Output (+)
Supply ignition circuit.
THIS CIRCUIT IS PART OF A SECURITY DEVICE; it must be
connected directly to vehicle's main ignition circuit.
5
Dark Blue
Starter
Output (+)
Connects to vehicle "Starter" circuit.
When the starter Kill option is used, connect this wire to the starter side
of the starter motor circuit.
6
Light Blue
Starter Kill
(Starter-cut) Input
Connects to key side of the starter motor circuit.
Allows starter circuit to be shut off when vehicle is remote started to prevent
"grinding" the starter motor. Also provides anti-theft function.
Anti-theft may be set to Active or Inactive in Stage 1 - level 4, page 18.
Anti-theft Default setting: Inactive.
7
Red Power Input
+12V power input, protected by a 30A fuse (F2)
Supplies "Ignition - Orange Wire" and the "Parking Lights - Green Wire".
P5 CONNECTOR
PIN DESCRIPTION PURPOSE
1
COMMON - 30 Pin 30 of standard Bosch type relay
2
N.C. - 87a Pin 87A of standard Bosch type relay
3
N.O. - 87 Pin 87 of standard Bosch type relay
The default setting is for Active while running
(Stage 1 - Level 9 on page 20).
An appropriate fuse must
protect Power supply for this circuit.
PLUG-IN ACCESSORIES CONNECTOR LIST
PLUG DESCRIPTION PURPOSE
P6
Shock Sensor Connector allowing a dual-stage shock sensor to be interfaced. See details on page 14.
P7
Additional Sensor
Connector allowing different types of sensors (single-stage) to be interfaced or to detect the
opening of the trunk lid. See page 14 for more details about this Input.
P9
LED (status)
LED used to display the manual sequence status and alarm/antitheft status.
See page 14 for more details about this connector.
P10
Dedicated
timer control
Negative trigger start input allowing a timer module to be interfaced. Requires a negative pulse
(0.7 sec.) to initialize remote start procedure. See page 14 for more details about this Input.
P11
Valet switch
Valet switch connector. Used for Alarm/Antitheft valet mode or for the Pager option.
See page 15 for more details about this connector.
P12
Manual Interface
Interface used to monitor doors and parking brake to validate safety sequence.
See page 15 for more details about this connector.
P13
Disabling switch Switch used to turn the remote start functions off.
P15
Antenna / Receiver Connector for the cable that plugs directly into the RF antenna / receiver module.
See page 15 for more details about this connector.
P16
IM / OM / IOM
Interfaces
Connector used for AstroStart alarm/immobilizer interfacing module. (IM / OM / IOM) See further
details packaged with the module and also page 15 for more details about this connector.