SECTION 1
GETTING ACQUAINTED
3
OPTIONAL FF14 FRICTION FEEDER CONTROL PANEL
Control Panel
1
SPEED
– Used to vary the speed of the Feeder in either the MANUAL or AUTO
Mode to provide separation between the pieces.
2
CONTINUOUS
– Pressing this switch with the Feed Select Switch in the
MANUAL position allows the Feeder tofeed continuously.
3
SINGLE
– Pressing this switch with the Feed Select Switch in MANUAL Mode
allows the Feeder to feed a single piece of media.
4
BATCH COUNTER
– Resettable to keep track of the pieces run on each job.
5
AUTO/MANUAL
– With the Feed Select Switch in MANUAL, the operator can
feed one or continuous pieces of media by pressing the FEED switches. When in
AUTO, the Interface controls the Feeder through an external device.
Front Panel
1
POWER RECEPTACLE
– Plug power cord here. Make sure that power cord is only
plugged into a properly grounded receptacle.
2
ON/OFF SWITCH –
Controls power to the Feeder.
3
FUSE HOLDER –
Fuse protects the electronics and motor in the Feeder.
4
INTERFACE CONNECTOR –
Used to control the FF14 Feeder. (See Interfacing for
more information.)
Summary of Contents for 3600P? 3800P
Page 4: ...TABLE OF CONTENTS ii Notes...
Page 8: ...SECTION 1 GETTING ACQUAINTED 4 Notes...
Page 33: ......