Astria.us.com
900720-00E
35
TROUBLESHOOTING
Continued
OBSERVED PROBLEM
POSSIBLE CAUSE
REMEDY
Either the remote or touch pad buttons
are pressed to start the burner ignition
sequence and there is no function or
response.
(Continued from
Page 34
).
6. LED is blinking
7. Igniter cable is not connected
8. Igniter cable pinched or wet
9. Broken Igniter cable.
10. Igniter electrode positioned wrong.
11. Igniter electrode broken.
12. Control module sounds 2 cycles
of 3 beeps; LCD display may show
ROM ERROR
13. Control module sounds 2 cycles
of 5 beeps; LCD display may show
SUPPORT ERROR
14. Bad reception from remote
15. If LED on touch pad is continu-
ously on, the cable is connected the
wrong way.
16. The control module sounds 2 cycles
of 5 beeps. The wiring assembly
from the control valve is discon-
nected or broken.
6. This indicates the battery power
is low. Replace the batteries in the
power supply box.
7. Check the igniter connection at both
the control module and the ODS pilot.
Connect if loose.
8. Free igniter cable if pinched by any
metal or tubing. Keep igniter cable
dry.
9. Replace wire harness including
igniter cable.
10. Replace ODS pilot assembly.
11. Replace ODS pilot assembly.
12. Replace control module
13. Ground cable from control valve
wiring harness is not grounding
properly. Reposition spade terminal
so that it makes contact with burner
chassis metal or valve body.
14. Change batteries in remote. Check
reception of signal from a shorter
distance. If still not working, try
changing the channel in the confi gu-
ration menu. If this does not fi x the
problem, reset the channel
(see
Page
24
Channel Selection)
and follow the
instructions in Pairing on
Page 28
.
Replace remote and control module
as a fi nal action.
15. Disconnect the touch pad between
the long and short cables, turn the
short cable with the touch pad over
and reconnect.
16. Connect the wiring harness at the
control module. Replace the valve
assembly if all other cause/remedies
fail to correct his problem.
