Astria.us.com
900720-00E
10
INSTALLATION
Continued
Figure 6 - Assembling Perimeter Trim
Figure 7 - Attaching Perimeter Trim to Fireplace
Side Trim
Slot
Mitered
Edge
Slot
Shim
Set Screws
Adjusting
Plate
Top
Trim
Mitered
Edge
ASSEMBLING AND ATTACHING OPTIONAL
PERIMETER TRIM
(Included with Mantel Accessory)
IMPORTANT
:
If you are recessing the fi rebox in a
wall, do not attach trim at this time. See
Built-In
Fireplace Installation
,
Page 12
.
NOTE
: These instructions show assembling and
attaching trim to fi replace.
1. Remove packaging from three pieces of
trim.
2. Locate four screws, two adjusting plates with
set screws, and two shims in the hardware
packet.
3. Align shim under adjusting plate as shown in
Figure 6
.
4. Slide one end of adjusting plate/shim in slot on
mitered edge of top trim
(see
Figure 6
)
.
5. Slide other end of adjusting plate/shim in slot
on mitered edge of side trim
(see
Figure 6
)
.
6. While fi rmly holding edges of trim together,
tighten both set screws on the adjusting plate
with slotted screwdriver.
7. Repeat steps 1 through 6 for other side.
8. Tighten trim hanging screws (#10 x 6.25
shoulder) into holes in cabinets. Place the
assembled trim onto fi replace cabinet. Align
hanging notches on trim with hanging screws
on side of fi replace
(see
Figure 7
)
. Push trim
fi rmly into place, sliding hanging notches over
hanging screws.
Trim
Hanging
Screws
Hanging
Notches
on Trim
Assembled Trim
Figure 5 - Installing Hood
Screw
Hood
Rail
ELECTRICAL HOOKUP
This fi replace includes a blower which must be
connected to either a wall receptacle or the electrical
receptacle that is included within the fi replace. If
the receptacle included with the fi replace is to be
used, it must be wired to a 120 volt supply by a
certifi ed electrician.
INSTALLING HOOD
Install hood to rail already installed in fi replace as
shown in
Figure 5
. Use 3 Phillips screws provided.
