Astria.us.com
900720-00E
23
OPERATION
1. Once you have activated the screen press the
MODE Zone or MODE/SET Button until you see
OFF.
2. Close equipment shutoff valve
(see
Figure 21,
Page 17
).
WARNING: If you do not follow
these instructions exactly, a fi re or
explosion may result causing property
damage, personal injury or loss of life.
WARNING: Burners will come
on automatically within one minute
when the selector switch is in the ON
position after the pilot is lit.
CAUTION: Do not try to adjust
heating levels by using the equipment
shutoff valve.
FOR YOUR SAFETY
READ BEFORE LIGHTING
A. This appliance is equipped with an ignition
device which automatically lights the pilot.
Do not light pilot by hand.
B. BEFORE LIGHTING smell all around the ap-
pliance area for gas. Be sure to smell next to
the fl oor because some gas is heavier than
air and will settle on the fl oor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use
any phone in your building.
• Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
• If you cannot reach your gas supplier, call
the fi re department.
C. Do not use this appliance if any part has been
under water. Immediately call a qualifi ed ser-
vice technician to inspect the appliance and
to replace any part of the control system and
any gas control which has been under water.
NOTICE: During initial operation of new
appliance, burning logs will give off
a paper-burning smell. Orange fl ame
will also be present. Open damper or
window to vent smell. This will only
last a few hours.
WARNING: You must operate this
fi replace with the fi replace screen in
place. Make sure fi replace screen is
installed before running fi replace.
LIGHTING
INSTRUCTIONS
1. STOP! Read the safety information in column
1.
2. Make sure equipment shutoff valve is fully
open.
3. Wait fi ve (5) minutes to clear out any gas.
Then smell for gas, including near the fl oor. If
you smell gas, STOP! Follow “B” in the safety
information, column 1. If you don’t smell gas,
go to the next step.
4. Press any button on the remote to power the
remote on. Press the MODE zone or the MODE/
SET Button to start the unit. You will hear a
beep from the control module and the pilot
will start to light the unit.
NOTE
: You may be running this heater for the
fi rst time after hooking up to gas supply. If so,
you may have to restart the unit several times
to allow the air to bleed from the system.
TO TURN OFF GAS
TO APPLIANCE
