C
H A P T E R
4
D
I S P L A Y I N G
M
A C H I N E
I
N F O R M A T I O N
1 2 4
6 7 0 0 B G
R I N D E R
O
P E R A T O R
S
A F E T Y
M
A N U A L
8 1 7 8 5 C
Compression Roll Stall Bump Page
◆
To access the Compression Roll Stall
Bump page:
1.
At the Machine Status page, press
F5
.
2.
At the Information Page, press
A
.
3.
At the Troubleshooting Menu page 1, press
F5
.
4.
At the Troubleshooting Menu page 2, press
C
.
The Peterson Adaptive Control System can sense when
the compression roll is stalled, as shown in Figure 146.
For the system to detect a stall, the following conditions
must exist:
•
The compression roll must be below 35 in. (90 cm)
(Max Bump Height).
•
The compression roll hydraulic pressure must be
above 4000 psi (C’roll Press).
•
Both of these conditions must exist for 0.5 seconds
(Bump delay time).
When these conditions are met, the adaptive control
system bumps up (lifts) the compression roll for 0.5 sec-
onds (Bump time).
Press
B
to adjust these settings.
To turn the stall bump feature on or off, go to the Adjust
page (see “Adjust Setup Menu” on page 130) and select
“Advanced Adaptive AG.”
See also “Peterson Adaptive Control System” on
page 118.
F05760
Figure 146: Compression Roll Stall Bump Page
