V4.4 03/08/18
TD0036
Page 20 of 39
This Document is uncontrolled when printed unless over stamped “CONTROLLED DOCUMENT”
6.6
CONNECTING EXTENSION CABINETS
If your system does not have extension cabinets you can skip this section.
Within each system the Receptor link cable will be coiled up with the Interface PCB.
NOTE:
If you are adding extension cabinets to an existing system, an Interface PCB will have been
provided for the existing system and must be fitted to the standoffs in the top of the cabinet as shown in
the image below.
1.
If not already connected, connect the Receptor Cable to the Interface PCB in the main cabinet as shown below.
2.
Thread the other end of the Receptor Cable through the cut-out in the left hand side of the cabinet.
3.
Connect it to the neighbouring Interface PCB.
