9
(617417440)
FM226A 10/18
Access 800
™
TCAC2 Series
Locks
Keypad Programming Instructions
Copyright © 2018 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
For installation assistance contact Corbin Russwin
1-800-543-3658 • [email protected]
5
M801, M803, M804, M806 Programming
Important
• Access800 TCAC2 controllers have replaced Access800 controllers for the
M801, M802, M803, M804, M805 and M806 Options (first generation Access800
controllers for these options are no longer available).
• All Access800 Series Products are now ordered by entering TCAC2 in the
Technology Code field in the order string when M801 – M806 Options are
selected.
• If your controller label does not have “TCAC2” refer to FM226 Keypad
Programming Instructions.
»
The keypad lock can support 2000 users. Each user is assigned a User Number in
addition to the code used for entry.
»
Accessware Version 2.0 applications software must be used with M802 & M805
(no keypad) controller for programming.
»
The Master Code is always User “01”. The Master Code assigns the Emergency
and Supervisor Codes and is also used for programming. Users are deleted
through the Master Programming Code only.
»
Emergency code is a 10 second unlock time and will override a thrown deadbolt
on a mortise lock.
»
TCAC2 locks allow multiple Supervisor users, the *default Supervisory Code is
User “02”.
»
Additional Supervisor users can be entered starting with User “03”. The
Supervisory Code allows temporary lock out of selected users, changes duration
of unlock time, requests infared interrogation output, and may add additional User
Codes.
»
The User Codes are entered at user number “03” or higher. User numbers do not
have to be used or entered sequentially.
Note: All User Codes must be followed by an asterisk (*).
»
The “Lock Out” user is location dependent – all users above the chosen user
number location are locked out of the keypad. To ensure that all users except
Master, Supervisor, Emergency and Panic are locked out, program this user at
user number location “03”.
»
The “Passage” user has precedence over all users except the “Panic” user. The
lock must be toggled back into a locked state for other users to function.
To Change the Master Code
99# 1234*
Yellow LED blinks
50# 1# 01#
Yellow LED blinks
New Master Code*
Yellow LED blinks quickly
New Master Code*
Yellow LED blinks slowly
*
Yellow LED goes out
This example uses the Factory Default
1234*
, yours may differ.
The Master Code must be changed (i.e., “Forced Change”) prior to adding any
other users.
