3
(617417440)
FM226A 10/18
Access 800
™
TCAC2 Series
Locks
Keypad Programming Instructions
Copyright © 2018 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
For installation assistance contact Corbin Russwin
1-800-543-3658 • [email protected]
2
General Programming
To Begin Programming:
The Lock Controller is preset at the factory with
Master Code “1234”.
It is strongly recommended
that the Master Code be changed as the first
programming step.
Entering 1234 * will unlock
the lock allowing the lever handle to retract the
latchbolt.
Initial Set-Up Procedures:
• The following are typical procedures to be used
when setting up your Access 800 lock.
• If a mistake is made during any of procedures,
depress the “*” key several times until the
yellow LED goes out.
• If no keystroke is made in a 30 second time
frame, the programming up to that point will
default and you will have to start over.
Lock Model: _______________________________
Door Name: ________________________________
Location: __________________________________
*Note: If memory is cleared, you must reprogram Emergency code. The Master code resets
back to 1234*.
3
Individual Door Log Sheet for Keypad Programming
Main Codes - User Programmed “Door” Log
Function
User Location
Default Code
User Programmed Code
Master Code
01
1234&
Supervisor Code
02
User Programmed “Door” Log
User Name
User Type
User Location
User Code
Card/Fob#, Notes
Determine which programming steps to use
for your lock:
• If your label has an M800, then use the
programming in Section 4. (Figure 1)
• If your label has an M801, M803, M804, or
M806, reference programming in Section 5.
(Figure 2)
• If your label has a M802 or M805,
Accessware™ application Software must
be used for programming. See Section 7.
(Figure 2)
Figure 1
Figure 2
M80X
White Button
M800
Grey Button
