8. Refer to Figure 16 and verify all mounting
dimensions.
NOTE:
An extra washer is supplied if needed to
prevent rubbing between the top of the door arm
and end link.
9. SLIDE the dress cover onto the operator.
5. Apply preload to ensure proper closing. THREAD
the adjustable door arm end link into the door arm
three revolutions so the hole in the arm is
approximately 1/2 diameter off from the hole in the
door arm pivot as shown in Figure 17.
7. CYCLE the door several times, and ENSURE that
the door opens and closes smoothly.
CAUTION
• SLIDE the door arm pivot as necessary to
align the door arm end link with the door arm
pivot mounting hole.
• TIGHTEN the socket head capscrews
securing the door arm pivot to the door arm
pivot bracket.
4. If the door arm end link does not align with the
door arm pivot mounting hole and there is no
available travel on the threaded end link,
PERFORM the following:
• LOOSEN the socket head capscrews securing
the door arm pivot to the door arm pivot
bracket.
In order to apply a preload to the door, the door arm
must be threaded into the door arm three revolutions.
Excessive pre-load will reduce the closing force of the
operator and may cause the door to stick in the open
position or the door arm to reverse.
6. INSTALL the washer provided onto the top of the
door arm end link, and TIGHTEN the 5/16 -18 X
7/8" button-head capscrew securing the door arm
end link to the door arm pivot bracket.
10. CONNECT the battery pack connector plug to the
operator.
12. SWITCH the battery pack to the “ON” position.
11. SLIDE the battery pack onto the operator, and
ENSURE that the battery pack wires will not
interfere with the operator cover.
Operator And Door Arm Installation Instructions - Push Side Applications
6
Figure 17
OPTIONAL
WASHER
700002-Rev N 09/18
®
5800 ADAEZ PRO
Installation and Operation Instructions
21 of 50
ADJUST ARM LENGTH
TO PROVIDE PRELOAD
Copyright © 2018, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights
reserved. Reproduction in whole or in part without the express written permission of ASSA
ABLOY Accessories and Door Controls Group, Inc. is prohibited.
