Failure display
In case of a failure while a program is in progress, the relevant Error XX is indicated on the display
unit.
Press the INFO button to display
the error description.
Switch off the appliance and turn
it back on.
Errors indicated on the display unit may include the following:
What to do?
Error indication on the
display unit
Error
Restart the program. If the error reoccurs, call a service
technician.
Incorrect settings
E0
Temperature sensor failure
E1
•
Inlet water too cold. Repeat the washing program.
•
If the appliance reports this error again, call a service
technician.
Turn the appliance OFF and then switch it again ON. Start the
program again. If the error reoccurs, call service technician.
Door lock error
E2
Check the following:
Water filling error
E3
•
is the water inlet valve open,
•
is the filter on the water inlet hose clean,
•
is the water supply hose deformed (clipped, clogged etc.),
•
is the pressure in the water mains between 0.1 and 1 MPa
(1–10 bar).
Then, press the
Exit
button to resume the program.
If the error reoccurs, call a service technician.
Restart the program; if the error reoccurs, call a service
technician.
Water heating error
E6
Check the following:
Water draining error
E7
•
is the pump filter clean,
•
is the drain hose clogged,
•
is the drain clogged,
•
is the drain hose fitted at the right height (see chapter on
drain hose installation in the instruction manual).
Then, press the Exit button again. If the error reoccurs, call a
service technician.
Turn the appliance OFF and then switch it again ON. Start the
program again. If the error reoccurs, call service technician.
Water level sensor error
E10
42
Errors – what to do?
