Start (pressed briefly – start/resume)
Pause (short press of the button - pause)
Stop (press and hold for 3 seconds – stop or cancel)
Remaining time
Depending on the selected program, anticipated washing time will be displayed in hours and minutes.
Actual washing time will depend on the selected program, load, type of laundry, spin speed etc.
Actual washing time may be longer or shorter than initially displayed.
Remaining time will be updated during the program duration, depending on the actual amount of
laundry and amount of water pumped into the machine. The last remaining time update takes place
before the final spinning cycle.
In case of uneven distribution of laundry, the time on the display will flash and it will not count down.
Once the laundry is evenly redistributed, the washing time will continue and it will stop flashing.
Adding or removing laundry after the start of the program
To add laundry during washing program, you must first select the
enable
/disable option. (See
chapter: SETTINGS).
To add or remove laundry during the progress of a washing program, use the Start/
Pause
button
to pause the program.
The door may be opened when the water is pumped from the machine (but not completely pumped
out). Then, add or remove the laundry. Close the door and continue the program. Press the
Start
/Pause button.
The program will resume from the point at which it was interrupted.
If the door cannot be opened, it is possible that the temperature in the machine is too high, and you
won't be able to add the laundry.
Also, if the door cannot be opened, it is possible that the program has been running for too long and
any laundry added at that point would not be efficiently washed.
Pausing, stopping or changing the program
To pause the program, shortly press the Start/
Pause
button.
To resume a program, press the
Start
/Pause button again.
To stop the washing program, press the Start/
Pause
button and hold it for 3 seconds.
Choose "Stop program". The program is canceled and the water is pumped out of the machine if
necessary. Only then will you be able to open the washing machine door. Use the Program selector
knob to select a new program. If necessary, add detergent, and then press the
Start
/Pause
button.
INFORMATION!
If the temperature in the drum is very high, then cooling procedure starts before program is
canceled.
28
Washing process step by step (1-8)
