28
ADJUSTMENT
The programme
Aut 40° Normal
is controlled via
temp sensor exhaust air.
The programme
Aut 40° Extra
is controlled via
temp sensor exhaust air
and a
time factor.
The programme
Aut 60° Normal
is controlled via
temp sensor exhaust air.
The programme
Aut 60° Extra
is controlled via
temp sensor exhaust air
and a
time factor.
The automatic programmes end automatically when the laundry is dry.
To decide when the laundry is dry, the actual exhaust air temperature is compared against a
parameter,
P2014 for 40°
programme and
P2024 for 60°
programme.
For
Aut 40° Extra
an extra drying time is additionally added according to parameter
P2015.
For
Aut 60° Extra
an extra drying time is additionally added according to parameter
P2025.
It is primarily these four parameters that are adjusted to optimise the drying processes of the
automatic programmes.
Aut 40° Normal
and
Aut 40° Extra
are adjusted with
parameter P2014
.
Aut 40° Extra
is additionally adjusted with
parameter P2015
(extra drying time).
Aut 60° Normal
and
Aut 60° Extra
is adjusted with
parameter P2024
.
Aut 60° Extra
is additionally adjusted with
parameter P2025
(extra drying time).
If it is found that the laundry does not dry suffi ciently, the parameter value is
increased
.
If it is found that the laundry is over-dried, long drying time, the parameter value is
reduced
.
Optimisation of drying processes must always take place in small steps, start by adjusting the
parameter concerned one to two units up or down. Then check the result after the next drying
process and make any further adjustment necessary.
