System setup
27 / 49
2. Click "Detect". The device will now start scanning. Trigger the sensor (triggering will depend on
the type of sensor you have, e.g. a motion detector is triggered by moving in front of it). Asema
E will give an indication when a signal has registered. Trigger the sensor again to confirm.
3. Then choose whether you want this sensor to switch appliances ON or OFF.
4. You will then be returned to the Sensors page. Click on the gear icon to edit the settings. Fill
in a name.
5. Click on connect to set what item the sensor should control. Select the item of your choice
(Action, Appliance etc.), and click on the arrow pointing to the right, to add it. (To remove items
on the right side, select them and click on the arrow point to the left). Click "OK".
6. In the "Select sensor type..." screen, click "OK". The sensor settings will now be saved.
6.2.3.2. Pairing sensors in the WebView
1. Go to WebView > Appliances > Sensors
2. Click "Detect". The device will now start scanning. Trigger the sensor. A popup will appear when
the signal has been registered. Trigger the sensor again to confirm.
3. Then choose whether you want this sensor to switch appliances ON or OFF.
4. You will then be returned to the Sensors page. Click on the gear icon to edit the settings. Fill in
a name and choose a room if applicable. To connect the sensor, select the item of your choice
(Action, Appliance etc.), and click on the arrow pointing to the right, to add it. (To remove items
on the right side, select them and click on the arrow point to the left).
5. Click "OK" and the sensor is saved.
6.2.4. Remotes
6.2.4.1. Pairing remotes on the device
1. Go to Main Setup > Appliances > Remotes.
2. Click "Detect". The device will now start scanning. Push a button on the remote. Asema E will
give an indication when a signal is registered. Push the same button again to confirm.
3. Then choose whether you want this remote to switch appliances ON or OFF.
4. You will then be returned to the Remote page. Click on the gear icon to edit the settings. Fill
in a name.
5. Click on connect to set what item the remote should control. Select the item of your choice
(Action, Appliance etc.), and click on the arrow pointing to the right, to add it. (To remove items
on the right side, select them and click on the arrow point to the left).
6. Click "OK". The remote settings will now be saved.
6.2.4.2. Pairing remotes in the WebView
1. Go to WebView > Appliances > Remotes
2. Click "Detect". The device will now start scanning. Push a button on the remote. A popup will
appear when a signal has been registered. Push the button again to confirm.
3. Then choose whether you want this remote to switch appliances ON or OFF.
