7
2.5 – ACTIVE SET POINT SELECTION
The instrument permits to pre-program up to 4 different Set point (
“SP1”
,
“SP2”
,
“SP3”
,
“SP4”
) and then to select which one
has to be active. The maximum number of Set point is determined by the par.
"nSP"
located in the parameters group “
]
SP
“.
The active Set point can be selected :
- Through parameter
"SPAt"
in the parameters group “
]
SP
“.
- Through key “U” if par. "USrb" = CHSP
- Automatically between SP1 and SP2 in case a time “dur.t” (see par. 4.8) has been programmed.
Set Point “SP1”, “SP2”, “SP3”, “SP4” will be visible depending on the maximum number of Set Point selected on par. “nSP”
and they will be programmable with a value comprised between the value programmed on par.
“SPLL”
and
“SPHL”.
Note
: in all the following examples the Set point is indicated as "SP", however the instrument will behave depending on the
Set point selected as active.
