4
2 - PROGRAMMING
2.1 – FAST PROGRAMMING OF THE SET POINT
This procedure permits to rapidly program the active Set Point and possibly the alarm thresholds (see par 2.3)
Push key “P”, then release it and the display will visualise
“SP n”
(where n is the number of the Set Point active on that
moment) alternatively to the programmed value.
To modify it, work on keys “UP” to increase the value or “DOWN” to decrease it.
These keys change the value one digit per time but, if they are kept pushed more than one second, the value is increased or
decreased rapidly and, after two seconds in the same condition, the changing speeds increases again to allow the fast
reaching of the desired value.
Once the desired value has been reached, pushing key P it’s possible to exit by the fast programming mode or it’s possible
to visualise the alarm thresholds (see par. 2.3).
To get out of the fast Set programming it’s necessary to push key P, after the visualisation of the last Set Point, or do not work
on any key for approx. 15 seconds, afterwards the display is coming back to the normal functioning.
2.2 – SELECTION OF THE CONTROL STATE AND PARAMETERS PROGRAMMING
Pushing key "P" and holding it pushed for approx. 2 sec. it’s possible to enter into the main selection menu.
Through keys "UP" or DOWN” it’s then possible to roll over the selections:
"OPEr"
It permits to enter into the operating parameters menu
"ConF"
It permits to enter into the configuration parameters menu
"OFF"
It permits to swap the regulator into the OFF state
"rEG"
It permits to swap the regulator into the automatic control state
"tunE"
It permits to activate the Autotuning or Selftuning function
"OPLO"
It permits to swap the regulator into the manual control state and therefore to program the % control value using
keys “UP” and “DOWN”
Once the desired item has been selected, push key “P” to confirm.
The selection "OPEr" and "ConF" give the possibility to accede to other menu containing additional parameters and more
precisely :
"OPEr" –
Operating parameters Menu: it normally contains the Set Point parameters but it can contain all the desired
parameters (see par. 2.3).
"ConF" –
Configuration parameters Menu: it contains all the operating parameters and the functioning configuration
parameters (alarm configuration, control, input, etc.)
