Operating Manual
SECTION 2
PROTEGE 5442P
10
112509 Rev G
4. Use an operating switch to lower the platform to the floor.
5. Enter the platform and use the operating switch located inside the platform to move
the platform upward until it stops.
6. Open the inner access panel on the left-hand machinery cabinet and remove the
height adjustment tool from its storage bracket. Refer to Figure 2 for identification of
the adjustment tool.
7. Use the adjustment tool to remove the magnetic optical reflector from the vertical
guide rail. To do so, place the adjustment tool on the reflector, turn it clockwise a
quarter turn to engage the reflector, and then pull the reflector off the guide rail.
Reserve the reflector in the adjustment tool until Step 11. The reflector is located
near the bottom of the cabinet and is marked by a yellow decal. See Figure 3.
8. Use an operating switch to move the platform so the platform floor is approximately
level with the upper landing.
Figure 3
Summary of Contents for 5442P
