134
Asanté IntraCore 36000 Series
Web
Click Priority–IP Port Priority
. Enter the IP port number for a network application in the IP Port Number
box and the new CoS values in the Class of Service box, and then click Apply.
Mapping specific values for IP Precedence is implemented as an interface configuration command, and any
changes apply to the all interfaces on the switch.
CLI
The following example globally enables IP Port Priority service on the switch, maps HTTP traffic on port 5 to
CoS value 0, and then displays all the IP Port Priority settings for that port.
Console(config)#
map ip port
Console(config)#
interface ethernet 1/5
Console(config-if)#
map ip port 80 cos 0
Console(config-if)#
end
Console#
show map ip port ethernet 1/5
TCP port mapping status: disabled
Port Port no. COS
--------- -------- ---
Eth 1/ 5 80 0
Console#
11.6 Mapping CoS Values to ACLs
Use the ACL CoS Mapping page to set the output queue for packets matching an ACL rule as shown in the
following table. Note that the specified CoS value is only used to map the matching packet to an output
queue; it is not written to the packet itself. For information on mapping the CoS values to output queues, see
section
2.10 Mapping CoS Values to Egress Queues.
Priority
0 1 2 3 4 5 6 7
Queue
1 2 0 3 4 5 6 7
