Chapter 2 Introducing the Aruba 8325 Switch
19
Reset button
The Reset button is recessed from the front panel (to protect it from being pushed accidentally) and is accessible
through a small hole on the front panel. Use a pointed object, such as an unbent paper clip, to push the button.
The Reset button is used as follows:
Switch product label
The switch product label is an Aruba Orange-colored tab on the bottom right side of the switch front panel. Pull the
tab out to view the product label information.
The product label information includes the part number, model number, serial number, and MAC address. The
information and bar codes are on two labels affixed to the top and bottom of the product label tab.
Management port Link
LED
To display link
information for the port.
On green
Shows a valid link.
Off
Port is disabled, not connected, or
not receiving a link beat signal.
Management port Act
LED
To display activity
information for the port.
Flashing green
Flashing indicates port activity.
1
The fast flashing behavior is an on/off cycle once every 0.8 seconds, approximately.
2
The slow flashing behavior is an on/off cycle once every 1.6 seconds, approximately.
To accomplish this:
Do this:
This will happen:
Soft Reset
Press and release the Reset
button
The switch operating system is
cleared gracefully (such as data
transfer completion, temporary
error conditions are cleared), and
then reboots.
Note: The Reset button is provided for your convenience. If you are concerned with switch security, make
sure that the switch is installed in a secure location, such as a locked wiring closet.
Table 12:
Port LED behavior for the Aruba 8325-32C (JL626A and JL627A) (Continued)
Chassis LEDs
Function
State
Meaning
